See Instructions
On the main table,  you can program the skater, the flag  to go around, and monorail to go back and forth
using the RCX at SENSORSCITY at Marshall University.

You also can see the rover move above the City
on the camera at http://legocamera.marshall.edu
as you Teleoperate it on http://lego.Marshall.edu.

There is also an NXT to run over the Internet.

Program an NXT robot to move around.
On the Submit mission page at SENSORSCITY be sure to run the correct program and click the correct platform.

Send programs to  SENSORSCITY.
- See Instructions-
Click this link for the directory with Example programs to use at SENSORSCITY.
 Click and save a file that ends in .vi to your computer to use to send a mission.
The RoboLab Programs are the files that end in .vi and the .jpg are pictures of the programs.
 Note:   A car goes between the Lamp on port A which is across from the light sensor on port 1.
 Monorail motor is on port B and touch sensors on both ends of the track are on port 2.
Port C changes each month.
Port 3 is a light sensor facing the flag stand.
(See the color challenge.)
 

Below is an example of the data you will get back.
The red line dips at each time the car passes in front of  light sensor on port 1.
The blue line steps up each time the touch sensor at an end of the monorail was touched.
The yellow line is the data back from the light sensor facing the Flag pole.

Color Challenge
See if you can tell what color is in front of the light sensor when the program stops.
Look at the camera
http://legocamera.marshall.edu
then look at your data to see if you are right.

Data that is returned when you run a program to the NXT vehicle shows distance to objects in front on the yellow data,
lines on the floor on the red data, and the touch sensor  is the blue data.
 can be watched through the camera on the Red Rover.

Various parts of the CITY also operate when you run programs through Red Rover.
To see the camera refresh faster use Red Rover as an Earth site.